MPS2 AN500 Board

Tags: arch:arm chip:mps vendor:arm

This board configuration will use QEMU to emulate generic ARM v7-M series hardware platform and provides support for these devices:

  • ARM Generic Timer

  • CMSDK UART controller

Getting Started

  1. Configuring NuttX and compile:

    $ ./tools/configure.sh -l mps2-an500:nsh
    $ make
    

Running with qemu:

$ qemu-system-arm -M mps2-an500 -nographic -kernel nuttx.bin

Configurations

citest

Flat build that the CI runs in QEMU with NTFC:

$ qemu-system-arm -M mps2-an500 -nographic -kernel nuttx

citest_protected

Protected build (CONFIG_BUILD_PROTECTED=y) that the CI runs in QEMU with NTFC. QEMU loads the kernel and the user image:

$ qemu-system-arm -M mps2-an500 -nographic -kernel nuttx \
    -device loader,file=nuttx_user.elf

Debugging with QEMU

The nuttx ELF image can be debugged with QEMU.

  1. To debug the nuttx (ELF) with symbols, make sure the following change have applied to defconfig:

    +CONFIG_DEBUG_SYMBOLS=y
    
  2. Run QEMU(at shell terminal 1):

    $ qemu-system-arm -M mps2-an500 -nographic -kernel nuttx.bin -S -s
    
  3. Run gdb with TUI, connect to QEMU, load nuttx and continue (at shell terminal 2):

    $ arm-none-eabi-gdb -tui --eval-command='target remote localhost:1234' nuttx